RALLY glossy white paint aerosol

Colour:

Product code: TE02224

Packaging:

Package: 5pcs.

It is suitable for the painting of metal, wood, glass and plastic surfaces outdoors and indoors. It dries rapidly, it has a good adhesion and hiding power and it provides a durable gloss. In case of outdoor use for steel surfaces, the use of anti-corrosion primer is recommended.

In case of plastics, compatibility test shall be performed.

It is sufficient to paint a of 2-2.5 m² (21.5-27 sqft) in a single layer.

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

Clean the surface to be painted from any contamination.
Perform painting on a dry surface and preferably between 20-25°C (68-77°F).
Shake the bottle for 1 minute after the start of the movement of the balls.
Spray the surface evenly and softly from a distance of about 20 cm (8 inch), which can be resprayed after 10 minutes of drying time.
After 12 hours, it can be repainted by MAESTRO shiny or flat acrylic lacquer.

In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.
The coating will be suitable for use after 60 minutes of drying.