RALLY caliper paint aerosol yellow

Colour:

Product code: TE02144

Packaging:

Package: 5pcs.

The paint is recommended for the painting of brake calliper, brake drum or metal surfaces subject to a temperature of max. 200°C (392°F).

It can be used for the painting of road wheels or wheel discs as well. The paint gives your car a sporty and unique appearance.

It withstands chemicals and corrosion. It perfectly keeps its colour and gloss and it is easy to clean.

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

If possible, perform spraying at a temperature of 20-25°C (68-77°F). Apply the paint on grease-free, oil-free, rust-free, sanded and dry surface.
Shake the bottle for 1 minute after the start of the movement of the balls.
Spray the surface softly from a distance of about 30 cm (12 inch), which can be resprayed after 15 minutes of drying time.

In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.
Prevent the paint to be sprayed to other metal parts.
The painted surface cannot be lacquered.