Car care

TE02450

PREVENT Zinc spray aerosol

Product code: TE02450
Packaging: 400 ml
Package: 5pcs.

The aerosol is suitable for the priming of the chassis elements of vehicles, for the permanent corrosion prevention of outdoor and indoor metal surfaces and for the repair of hot dip galvanised workpieces with injured surface. 


The paint is weatherproof, has light colour and is heat resistant up to 300°C (572°F). It is ideal for spot welding.  It rapidly dries on and perfectly adheres to all metal surfaces. 


It contains a zinc pigment with a purity of 99%. 


The zinc coating can be re-lacquered with PREVENT wheel disc lacquer.  


The content of the bottle is sufficient for the single-layer painting of a surface of about 2 m2 (21.5 sqft).

    Other product info

    ADVICE FOR PAINTING, AEROSOL TECHNIQUES

    The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

    The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

    Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

    The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

    In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

    Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

    Keep up the good work!

    The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

    Using instructions

    • Shake the bottle for 2-3 minutes after the start of the movement of the balls. 


    • The basic surface must be clean, dry and free from rust and grease.


    •  Apply the first layer thinly to increase adhesion.


    •  After 10 minutes, the surface can be re-sprayed. The increase in the number of layer increases the corrosion prevention effect as well.


    • In case of the incidental clogging of the valve, operate the bottle by turning the nozzle. 


    • After use, operate the bottle upside down for 2-3 seconds.

       The optimal temperature for application is 20-25°C (68-77°F).


    Comments

If you would like to write a comment please sign in!
Loading

    Questions, answers

    If you want to write a question please sign in!
    Loading

Similar products
PREVENT underbody coat aerosol
PREVENT underbody coat aerosol
PREVENT primer filler aerosol
PREVENT primer filler aerosol