MAESTRO zinc primer paint aerosol

Colour:

Product code: TE01636

Packaging: 400 ml

Package: 5pcs.

The MAESTRO zinc primer aerosol is perfectly suitable for the permanent corrosion protection of outdoor and indoor metal surfaces and for the correction of injured priming and cold galvanised surfaces.

It dries and adheres well, it can be re-welded and provides a heat resistant surface up to 100°C (212°F). The surface can be resprayed after 10 minutes of drying time.

The zinc coat can be lacquered with MAESTRO nitro or acrylic laquer or can be painted by MAESTRO acrylic paint. For the painting or lacquering above, at least 3 hours of drying time is necessary.

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

Thoroughly remove the rust from the surface.
The paint shall be sprayed on a cleaned and dry surface, preferably at 20-25 °C (68-77°F)!
Shake the bottle for 2-3 minutes after the start of the movement of the balls.

During use, repeat shaking multiple times.
Evenly and thinly spray the surface of the metal. If larger corrosion resistance is required, the process can be repeated after 10 minutes.
Before the application of the finishing paint or the lacquer, at least 3 hours of drying time is necessary.

In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.