MAESTRO zinc spray

Colour:

Product code: TE02214

Packaging: 400 ml

Package: 5pcs.

This aerosol is suitable for durable corrosion protection of indoor and outdoor metal surfaces and for the repair of dip galvanized pieces with a damaged surface.

Using the spray, a weather-resistant zinc coating can be created which has a light colour - similar to hot-dip galvanization - and is heat-resistant up to 300 °C.

It is excellent before weld pointing. It dries quickly on all metal surfaces and adheres excellently. The paint contains 99% pure zinc pigments.

The zinc coating can be painted over with MAESTRO nitro lacquer. The contents of the can are sufficient to paint approx. 2 m² surface in one layer.

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

The basic surface must be clean, dry and free from rust and grease.
Shake the bottle for 2-3 minutes after the start of the movement of the balls.
The basic surface must be clean, dry and free from rust and grease.
Apply the first layer thinly to increase adhesion.
After 10 minutes, the surface can be re-sprayed. The increase in the number of layer increases the corrosion prevention effect as well.
In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.

The optimal temperature for application is 20-25°C (68-77°F).

Comments

If you would like to write a comment please sign in!

Questions, answers

If you want to write a question please sign in!

Hobby, DIY paint aerosols

MAESTRO zinc spray

Other product info

Using instructions

The basic surface must be clean, dry and free from rust and grease.

Shake the bottle for 2-3 minutes after the start of the movement of the balls.

The basic surface must be clean, dry and free from rust and grease.

Apply the first layer thinly to increase adhesion.

After 10 minutes, the surface can be re-sprayed. The increase in the number of layer increases the corrosion prevention effect as well.

In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.

After use, operate the bottle upside down for 2-3 seconds.

Comments

Questions, answers

Similar products